How to remove the starter from John Deere 620i gator

https://www.gatorforums.net/forum/gator-performance-modifications/14503-gator-2008-620i-xuv-4x4-fuel-pump-replacement.html

25 psi.

Try a reboot. Disconnect the ground lead from the battery for 15 seconds, then reconnect and try again.

check starter bolts pull plug and do a compression test clunk in engine never good possible spun rod bearing

Look in the owners manual

YOU DONT! Factory specs are need to test and set it!

First off what is the problem you are having????

All the TPS does is switch from one timing curve to the other on the cdi, and is also connected to the fuel management computer to tell it when to increase fuel delivery.

If you are having running problems start with old fuel, fuel pump pressure, and last if you have modified the airbox or exhaust in any way it will run like crap! On fuel injection you have to get a tunable fuel management computer when increasing air-flow or exhaust flow. The fuel injection is set from the factory based on the OEM parameters.

How many hours/ miles on your unit?

Have the valves been adjusted if it has over 200 hours of use?

are there any codes being flashed on display when key is turned to on position but not running?

if battery is good, check to see if you have voltage at solenoid. if you do, turn key to start, that should throw the fire from other side of solenoid to starter. if there is no fire on the other side of solenoid when you turn the key,then your solenoid is most likely bad.

hi, I will need a bit more info

too heavy a load

not adjustable.