Question about Polaris ATV

3 Answers

I have a 2005 Polaris 800 it works fine in R N and L But it will not shift past these into park or high. Any ideas?

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Apply foot brake

Posted on Mar 27, 2012

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

Just on top of the frame and under the engine, filled up with mud and stones, stopping mine from shifting properly. I pressure washed it out, now it works fine.

Posted on Oct 06, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 38 Answers

Check your linkage for adjustement or wear

Posted on Oct 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Polaris sportsman 700 efi has a shift lever problem. It says in low where the high position should be. is it stripped or is there a way to adjust it?


your shift linkage could be out of adjustment. the two rods that run to your transmission. try disconnecting one and see if it shift *(without the engine running), then do the same thing for the other. if it shift into high without the low gear shift linkage disconnected, then they are out of adjustment.

Nov 03, 2017 | ATVs

1 Answer

Hard to shift out of 1st gear


hard to shift gears - Polaris ATV Forum

www.polarisatvforums.com > ... > Polaris Sportsman
Jun 28, 2010 - my 06 500 efi creeps and sometime is a little hard to shift. the dealer told me ... inline. if its off a little when you are stopped and trying to shift the tranny has... 2013 RZR XP 900 .... shop, for first service and to put in a new belt, blew up the firstone already. ... what makes a polaris crew hard to change gears.

Won't shift with motor running. Need help please - Polaris RZR ...

www.rzrforums.net > ... > General RZR > RZR-S Specific Discussion
Mar 6, 2012 - It will not shift in any gear with the motor running, but if I turn it off I can.... First Name: Jeanie ... 2013 Grizzly ... LE - Muzzy, UMP, Donaldson, TS Seats, FixMyToys parts.. and a lot of hard work .... 2005 polaris sportsman 500 shifter problems stuck in reverse ... polaris ranger 700 crew wont shift when running. How to adjust shifter
Nov 27, 2013
Issue: In gear, but will not drive
Oct 22, 2012
Gear Grinding
Oct 7, 2012
HELP trans is hard to shift
Jan 26, 2011
More results from www.rzrforums.net

Ranger Problems & Solutions [Archive] - PRC Polaris


Dec 30, 2015 | Polaris 2013 Ranger Crew 500

2 Answers

Tranny works, shifter wont shift the gears. how to fix?


My 2005 Polaris ATP 500 requires I depress the right foot brake while shifting into reverse or down into low range. Perhaps some adjustment on the foot brake to make this work. Also check linkage to make sure it is not binding. Others say if the idle speed is too high, you may not be able to shift. Try shifting with the engine off to see if it goes into the gears, using the foot brake. If yes, try again while at low idle speed.

Mar 25, 2015 | Polaris 2004 Sportsman 500 H.O

3 Answers

I parked my Polaris 500 about a year ago just put new battery in started right up but doesn't go into foward or reverse


If it is stuck, try to rock it back and forth while attempting to shift. This has worked for me in the past. It sounds like oil wasn't replaced after going through mud / water before storing.

Jan 05, 2015 | Polaris 2004 Sportsman 500 H.O

1 Answer

My 2005 polaris phoenix 200 starts and idles fine but when i go to give it gas it dies


sounds like your high jet in the carb is either clogged or you have water in your fuel.

Apr 13, 2014 | Polaris 2005 Phoenix 200

1 Answer

I have an ATV Polaris Sportsman 800 that will not go into 4WD while in reverse with the over ride button pressed in. It did not work one day then worked the next and now seems to be out for good. 4 WD...


The over RIDE button is not used for shifting.
it is used to over RIDE the REV LIMETER while in reverse ( for applications such as plowing)
shifting into 4wd while moving is safe on some vehicles, but can cause catastrophic damage on others.
be ABSOLUTELY sure your vehicle is designed for SHIFT ON THE FLY .
If you aren sure, then come to a complete stop befor shifting.

Nov 30, 2017 | Polaris ATV

Not finding what you are looking for?
Polaris ATV Logo

Related Topics:

373 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polaris ATVs Experts

john h

Level 3 Expert

15387 Answers

Matt Olenzek
Matt Olenzek

Level 2 Expert

297 Answers

Wade Mobley
Wade Mobley

Level 3 Expert

513 Answers

Are you a Polaris ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...