my artic cat 2008 700EFI 4X4 starts and runs fine till its hot then it starts missing and kills starts right up but continues to kill I've changed the voltage reg I changed the spark plug even changed the intake bootmy artic cat 2008 700EFI 4X4 starts and runs fine till its hot then it starts missing and kills starts right up but continues to kill I've changed the voltage reg I changed the spark plug even changed the intake boot
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
coil you can test if you have a coil tester but doubt you do. CDI cant be tested. could also be a pick up coil on the stator, ignition switch, kill switch, tether if it has one.
Sometimes when bad parts heat up they fail. I have seen this with the cdi. Be very aggressive when checking your connections. Do you lose spark after it has been run for a while or at certain temps?
? 9:58
https://www.youtube.com/watch?v=iwwl4LPyOCY
Dec 29, 2009 - Uploaded by BlaineDP
When in the "OFF" position the switch will ground the ignition wireto the chassis effectively "grounding out" the ignition systemkilling the spark. ... becomes disconnected or if a wire gets cut then the switch will no longer turn off the engine. ... Testing a stator in a snowmobile Arctic cat - Duration: 3:25.
If the connection to any switch; key, kill, tether, throttle safety switch, etc.. is ... Some older model Arctic Cats have the ground up closer to the handle bars on ... Here is a general rule of thumb for putting spark plug wires on which cylinder for Cats: ... Pulledthe ECU cover off and found some corrosion; I had a 580 that did not ...
guessing you changed the spark plug? .. you can fry the coil from heat...I used to wrap coils in rags when I tested them on a coil tester to try to make them break down from the heat quicker. It worked too.
my 2008 artic cat 700EFI starts and runs fine till it warms up real good then it misses and kills I've changed the voltage reg the sparkplug even the intake boot it will only keep running if I keep the throttle open but still runs ruff I get an "E" message but no details as to why or what it means
my artic cat 2008 700EFI 4X4 starts and runs fine till its hot then it starts missing and kills starts right up but continues to kill I've changed the voltage reg I changed the spark plug even changed the intake boot
×