Question about ATVs

1 Answer

Wont start I can't get it to start. It was on its side in a hole when it was last running.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Ur piston ring may blowed up, but first check gas pump or oil pump.

Posted on May 08, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

300 arctic cat wont idle and shuts off


Sounds like a small jet in the carb is plugged up. You can take carb out and apart and make sure it's clean especially small hole between float bowl and intake. Do not force anything through holes or use anything that might make the hole larger ie. small drill bit.

Apr 10, 2017 | ATVs

1 Answer

95 Suzuki kingquad 350 will not idle at all. Starts and runs OK just wont idle. How do I fix this problem?


Try adjusting the idle screw on the side of the carb. If this don't work you need to clean the carb the pilot key is blocked. Regards Jom...

Apr 28, 2015 | ATVs

2 Answers

Why does my yamaha 660 only run if the choke is on? What causes it to backfire?


Most of the time it's because the Pilot/Idle jet is clogged in the carburetor. This most often happens because of old fuel sitting in the carburetor during long periods of sitting and non-use. The fuel forms a varnish - a gummy layer inside of your carburetor and clogs the tiny holes in the idle jet. Since fuel can't get through, the engine dies. The hole for the choke is larger, therefore the fuel can still get through it.

clogged carb jets Google Search

Jul 20, 2014 | Yamaha 2005 Grizzly 660 Auto 4x4

1 Answer

Was installing a winch on my 2009 prowler 700 xtx hooked positive cable to selanoid winch did not work,hooked direct to battery,works,rig wont start


Where did you ground the winch motor? You need a separate, heavy duty, switch with a relay to transfer the positive side voltage properly... DO NOT ground to the battery..use a clean, free of paint, place to ground. You may have fried the solenoid..do not connect the positive side to the solenoid. Direct connection to the + battery from the relay is good with a good waterproof fuse in line. Sometimes I have seen the "maint. free" batteries die when used "wrong" and still show 13 volts+.

Apr 08, 2014 | Arctic Cat 2009 Prowler 700 H1 EFI XTX 4x4

1 Answer

99 400ex wont start after its already been running


do a compression test when it's cold and then when it's hot. see if theres a difference.

Mar 27, 2014 | Honda 2007 TRX 400EX

2 Answers

Wont start or stay running unless battery charger is on it


some four wheelers require a battery to run correctly. sounds like you need a new one.

Mar 26, 2014 | ATVs

1 Answer

Timing on a kfx 50


there should be a hole in your flywheel that line up with the screws and your coil loosen it up and you slide it back and forth hard to get it so far out that it wont start though if possible it would be easier for you to pull the flywheel then you can adjust it by hand starting the center and see how it does

Jan 31, 2014 | kawasaki 2007 KFX 50

1 Answer

Stalling out while riding


think u correct saying it flooding had same problem sticking float
now and again changed float no more problem or getting starved of fuel.

Jul 15, 2013 | Polaris 2010 Sportsman 500 H.O

2 Answers

2008 polaris sportsman 500 won't start, but relay clicks and will start when relay terminals are jumped


I have seen this on a few machines. Start tracing wires. Ground wire from the key is the first on Id check. Grounds on these machines go bad from vibration and rough terrain. Not to mention silt in the water.

Feb 16, 2013 | Polaris ATV

Not finding what you are looking for?
ATVs Logo

Related Topics:

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top ATVs Experts

john h

Level 3 Expert

11057 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

 Scott Tx
Scott Tx

Level 2 Expert

516 Answers

Are you an ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...